Using SSH ControlMaster for Single Sign-On
OpenSSH has an option called
ControlMaster that enables the sharing of multiple sessions over a single network connection. This means that you can connect to Odyssey once, enter your password and PASSCODE, and have all other subsequent
ssh sessions (including
rsync, etc. that run over
ssh) piggy-back off the initial connection without need for re-authentication. You can specify such options each time on the command line, but it’s easiest if you put it in your
ssh client configuration file so that it applies every time.
On your Mac or linux desktop or laptop, create a text file
~/.ssh/config with, for example, the following contents:
myusername is replaced appropriately. This sets things up so that whenever you ssh to the host nickname
it’ll look for the special file (a socket) in your
~/.ssh/ directory that is maintaining a connection to Odyssey. If it already exists and is open, it’ll use it to create a connection without re-authenticating; if it doesn’t exist, it’ll authenticate and create the file for subsequent use.
Note that all subsequent connections are dependent on the initial connection — if you exit or kill the initial connection all other ones die, too. This can obviously be annoying if it happens accidentally. It’s easiestly avoided by setting up a master connection in the background, e.g.:
ssh -Y -C -o ServerAliveInterval=30 -fN ody
-fN make it go into the background and sit idle, after authenticating. (
-Y for X fowarding,
-C for compression, and
-o ServerAliveInterval=30 to prevent dropped connections have nothing to do with the
ControlMaster but are almost always helpful.)
Note that all port fowarding, including X display forwarding, must be setup by the initial connection and cannot be changed. For example, if you set up a master connection when sitting at your desktop, and then later
ssh to the desktop itself and use that ody connection, X programs that you run will open on the desktop’s display, not the display of the computer you’re now connecting to the desktop from. Likewise, if you forget to use
-Y on the initial connection, you will not be able to open X programs on subsequent connections.